Rorke Data The Galaxy 65 Especificações descarregar pdf (Página 36)

Galaxy GHDX-2422S-8+12F4D Installation and Hardware Reference Manual

Rackmounting

2-8

2.7 Rackmounting

The subsystem is easily installed into a standard 19-inch rack cabinet using the mounting

holes on the sides of chassis.

The enclosure chassis can be installed using self-purchased mounting rails, or GAL-

9272CEslide28 and GAL-9272CEslide36 rails.

2.7.1 Considerations for Installation Site and Chassis

• Make sure you have an appropriate site location and cables prepared with adequate

lengths to connect to main power and other devices.

• At least two people will be required to install the chassis. Disk drives should only be

installed after the chassis is properly mounted. The chassis can weigh about 24Kgs

without disk drives.

• The following tools are necessary for mounting the chassis:

 #4 Phillips-head screwdriver

 Wrenches may be necessary, depending on the rack type

• Use the included M5 or M6 screws for securing the chassis through its front

mounting ears.

• More details about the use of optional slide rails are given in the Installation Guide

that came with the slide rail package.

2.7.2 Mounting Holes Positions

• Integrators may design their own brackets or slide rails using the twenty-two (22)

mounting holes on the sides of chassis.

• There are six (6) mounting holes with six (6) M4 nuts near the end of the chassis on

each side. Shown below are the locations of these mounting holes. (See the arrow

marks in Figure 2-2). See the next diagram for another group of mounting holes on a

horizontal line.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 99 100

Sem comentários

Rorke Data The Galaxy 65 Especificações Página 36