Rorke Data The Galaxy 65 Especificações descarregar pdf (Página 64)

Galaxy GHDX-2422S-8+12F4D Installation and Hardware Reference Manual

Power On

4-8

 Firmware and RAIDWatch – The overall status of the system may be checked

using the pre-installed firmware or the RAIDWatch GUI.

 Audible Alarm - If any errors occur during the initialization process, the

onboard alarm will sound in a hastily repeated manner.

Drive tray LEDs should normally start flashing, indicating the RAID control units are

attempting to access the hard drives.

NOTE:

The subsystem has been designed to run continuously. Even if a component failure

occurs the fault can be corrected online.

4.2.5 LCD Screen

When powering on the subsystem, the following messages should appear on the front

panel LCD screen. Wait for the front panel LCD to show “READY” or “No Host LUN”

before the host boots up. Refer to Figure 4-5 on how to read the screens.

Figure 4-5: The LCD Initial Screen

The LCD screen startup sequence is shown and described in the sequence below.

This screen appears when the PSUs are turned on.

System is performing a self test.

GALAXYHD

Ready

Model Name

Status/Data Transfer Indicator

Initializing….

Please Wait...

Power on Self

Test. Please Wait...

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 99 100

Sem comentários

Rorke Data The Galaxy 65 Especificações Página 64